Additives
SA5 RETARDER FOR SPRAY AND BRUSH APPLICATIONS
For use in all Target Coatings 1000 Series Lacquers, WB6000 Lacquers and Oxford Hybrid Series finishes, and 9000 Series Polyurethanes.
SA5 reduces the viscosity of these coatings and slows down the dry-to-touch times to better control film formation during less then ideal conditions. SA5 Retarder helps waterborne urethane wood finishes flow and level during extensive brush applications when an extended wet-edge is required to prevent lap-marks and pulls in the finish. SA5 Retarder is also functional as a spray additive when used to control leveling during high temperature/low humidity conditions. Also, SA5 will help control blushing during low temperature/high humidity environments.
DIRECTIONS FOR USE
| 1. | Measure 2-15% by liquid volume of SA5 to be used in coating. |
| 2. | Slowly pour SA5 into coating being reduced, mix well during addition. |
| 3. | Adjustments of SA5 percentages may be needed to achieve spray or brush results required. Do not exceed 15% by liquid volume. |
| 4. | After addition of SA5, allow the thoroughly mixed solution to settle and synergize for a minimum of 30 minutes before using. If SA5 is not properly incorporated into the finish, fisheyes and poor leveling may occur. If poor film formation occurs, continue to mix SA5/finish solution and allow to settle for 1 hour before use. Do not add additional SA5. |
Note: If CL100 Cross-Linking Catalyst is also being used add SA5 after catalyst. See directions on catalyst bottle for proper use and handling.
Disclaimer: The information and suggestions in this website are, to the best of our knowledge, reliable. Since the conditions of use are beyond our control, this company cannot
assume responsibility for any risk or liabilities that may result from the use of its products. The Oxford® Brand Name is a trademark of Target Coatings, Inc.