Ultima-WR Stain
Ultima-WR Stain System WR4000 water-reducible (part #wr40xxx): product specifications and directions for use
PHYSICAL SPECIFICATIONS (Clear Base)
| Solids by weight | 24.0 – 26.0%nv |
| Weight Per Gallon | 8.50 lb./Gal. |
| Viscosity | 20 sec. Zahns 2 Cup |
| Shelf Life | 24+ Months |
| pH | 8.0-8.5 |
| VOC Content | 170 Grams / Litre ASTM-24 Method (Minus Water) |
| HAPS | 0.0 |
| Flash Point | 212°F (100°C) |
DIRECTIONS FOR USE
| 1. | Ensure that all surfaces to be stained are free of any contamination that may cause poor adhesion or leveling. Thoroughly clean the surface to be stained with denatured alcohol or clear, fresh water before proceeding. If water is used, remove any grain rise with the appropriate grit, stearate-free sandpaper required for good grain control. |
| 2. | After production sanding, continue to sand with stearate-free paper up to a minimum of 220-grit. This will help eliminate any production sanding defects and eliminate grain rise. Remove all sanding dust before applying stain. DO NOT USE WAX/OIL based tack clothes. |
| 3. | Thoroughly mix the contents of the Ultima-WR Stain before applying. Apply stain evenly via rag, brush or spray gun. Allow stain to penetrate into the wood grain, then wipe off excess stain to control color tone and color depth. Allow the stain to dry until the surface is no longer tacky to the touch. Reapply stain as required to maintain color continuity. Allow the last coat of stain to dry for a minimum of 2 hours at moderate room temperatures before applying Oxford/Target sealers and topcoats. |
CLEAN UP
Ultima-WR Stains are 100% water soluble and clean up with basic tap water and a mild detergent. All cloth rags used for the application of this product must be THOROUGHLY RINSED IN WATER before properly disposing of the used cloth. Rinse brushes and spray equipment with tap water and a mild detergent, followed by a clean, fresh water rinse before storing. Unused Ultima-WR Stain must be stored in a well-marked, tightly closed container. WARNING: KEEP OUT OF REACH OF CHILDREN
Disclaimer: The information and suggestions in this website are, to the best of our knowledge, reliable. Since the conditions of use are beyond our control, this company cannot
assume responsibility for any risk or liabilities that may result from the use of its products. The Oxford® Brand Name is a trademark of Target Coatings, Inc.